Kirk L-bracket

Description

I purchased this L-bracket in May, 2021. I am selling my Z6II so I am getting rid of this. It's practically new with no signs of use. Below is the information about the L-bracket I found on B&H Photo.
BL-Z7II L-Bracket for Nikon Z 7 II, Z 6II, and Z 5 Cameras
The
BL-Z7II L-Bracket for Nikon Z 7 II, Z 6II, and Z 5 Cameras
from
Kirk Enterprises
is designed with anti-twist flanges that prevent unwanted camera movement within the bracket. Its Arca-type compatible dovetail design enables the camera to mount in a vertical or horizontal position when shooting together with a tripod and compatible head.
The black anodized 6061-T6 aluminum L-bracket has a slotted design for side port access and does not block the LCD monitor from tilting. It allows access to controls, ports, and the battery door, and has a hand strap loop machined on the right-hand side. The base incorporates a stainless steel QD (Quick Disconnect) System receiver for a sling or shoulder strap. The included 5/32" short hex wrench is used to tighten the L-bracket to the body and then can stored via the built-in hex wrench storage system. A 1/4"-20 mounting hole is located on the bottom and sensor centering lines are on the back for precision the camera alignment can on a tripod head. The BL-Z bracket is compatible with the FTZ adaptor but will only work when there is not an L-bracket or plate attached to the FTZ adaptor.
NOTE: The BL-Z7 II does NOT fit the Nikon Z 7 or Z 6 camera bodies.
Change vertical or horizontal orientation without losing the center of axis
Arca-type compatible dovetail design
Sensor centering lines on the rear of bracket
Complete access to battery door and camera ports
No interference to LCD screen movement
Compatible with the FTZ adaptor
Compatible with the industry standard QD (Quick Disconnect) System
Machined from black anodized 6061-T6 aluminum